Rimage PrismPlus! User's Guide download pdf (Page 14)

Chapter 2

Installation

This chapter describes:

• Unpacking and re-packing the CD printer

• Setting up the CD printer

• Installing the print ribbon

• Installing software

Unpacking the Printer

Consider the following when unpacking the printer:

• Lift the printer out of the box carefully.

• Remove foam from under the printer cover.

• Save the packing foam, in case the printer needs to be returned for service.

• If the printer has been stored in a cold environment, allow it to reach room

temperature before powering on.

• Set the printer on a solid, flat surface.

• Inspect the container and printer for any signs of damage that may have occurred

during shipping.

Note: If any damage has occurred, call the company from where you purchased the CD

Printer.

As well as this User’s Guide, verify that you have the following materials when

unpacking:

• Printer

• Power cord

• Parallel cable

• Ribbon (installed at the factory)

• Supply roller (installed at the factory)

• Take-up roller (installed at the factory)

• CD Designer Software (includes print driver)

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 74 75

No comments

Rimage PrismPlus! User's Guide Page 14