Rimage PrismPlus! User's Guide download pdf (Page 14)

Rimage AutoPrinter II

b. If the disc is not

centered on the print

pad, loosen the two

Side to Side Alignment

Screws.

c. Slide the printer, NOT

the printer drawer, until

the side gaps are equal.

d. Tighten the two Side to

Side Alignment

Screws.

3. To perform the front to back

alignment procedure, turn

the Front to Back

Alignment Screw until

there is a 1/16” (1.5mm) gap

between the front edge of

the disc and the raised edge

of the Disc Retainer.

 Tip: You can use the T25

Torx driver or a 5/32” Allen

wrench to turn the Front to

Back Alignment Screw.

4. When the printer is aligned, raise the lift arm out of the way of the print drawer.

5. Close the print drawer by pressing the printer button.

6. To release the disc from the gripper, hold the disc while pressing the disc release button.

Aligning the Prism printer

After installing the printer, or if discs are not placed on the printer properly, the printer may need

an alignment to the gripper arm.

1. Power on the AutoPrism by pressing the AutoPrism power switch.

2. Prepare the AutoPrism for alignment.

a. If the lift arm is not at the top of the AutoPrism, manually move the lift arm to the top.

8 110656_G

1 2 ... 9 10 11 12 13 14 15 16 17 18 19

No comments

Rimage PrismPlus! User's Guide Page 14