Rimage PrismPlus! User's Guide download pdf (Page 11)

Operate the AutoPrinter II

Installing the carousel

You may load discs in the bins before installing the carousel.

-Important: To prevent errors, the carousel should be installed before operating the software

or powering on the AutoPrinter.

1. Slide the Carousel in so that the Shaft

slides in the slot opening of the Bearing

Guide.

2. Lower the carousel with the Top Support

Bearing dropping in to the Bearing Guide.

3. If necessary, rotate the Carousel to seat

the carousel securely.

Loading discs

You can load up to 100 discs in a carousel bin. You may load discs in the bins before installing

the carousel.

When the carousel is installed in the AutoPrinter, discs can be installed one bin at a time.

1. To move the required bin forward, press the Operator Button on the AutoPrinter.

2. Place blank discs to be printed in bins 1 – 3.

3. If the AutoPrinter starting to pick discs from bin 2 or 3, lift the carousel up and down so the

Carousel Present LED lights on and off. This informs the AutoPrinter to start picking discs

from bin 1 again.





Note: The AutoPrinter selects discs from bin 1 before picking discs from the next bin.

Tip: Hold the discs by the outer edge so you do not put fingerprints on either the top or the

bottom surface. Fingerprints on the top can affect printing. Rimage recommends wearing lint-

free gloves.

Unloading discs

1. Press the operator button to position the required bin forward.

2. Remove completed discs from the bin.

3. Repeat steps 1 - 2 until the required bins are empty.

110656_G 5

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18 19

No comments

Rimage PrismPlus! User's Guide Page 11