Rimage Amigo II User's Guide download pdf (Page 10)

Rimage Amigo II

4 110654_F

Operate the Amigo II

This section provides information that you need to produce CDs or DVDs with the Amigo II.

Powering on the Amigo II

1. To power on the Amigo II, press the power

switch on the rear of the Amigo II. The Amigo

II initializes.

2. To power off the Amigo II, press the power

switch again.

Power

Switch

Pausing the system

1. To pause the Amigo II, open the door.

2. To resume operation, close the door.

Loading and unloading discs

1. Load the discs.

a. Open the door.

b. To rotate the carousel and place a bin in position

to load discs, press the operator button.

c. Place discs to be recorded in the input bin (Bin 1)

of the carousel.

- Important! Place the disc with the recording

side facing down.

# Tip: Bins 2 & 3 may be either input or output

bins, depending on how the software is

configured.

d. Repeat steps b - c until the required bins are filled.

e. Close the door.

2. Unload the discs.

a. Open the door.

b. To rotate the carousel and place a bin in position to remove discs, press the operator

button.

c. Remove the discs from the bin.

d. Repeat steps b - c until the required bins are empty.

e. Close the door.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 18 19

No comments

Rimage Amigo II User's Guide Page 10